How much boost on your stock motor???

[juno]

There seems to be a trend with folks going with higher compression motors on their PA's.

The old addage was lower the compression to 8.5 or so and crank the boost.
With our stock high compression (9.85) and heavy-ass cars, we are a good sample group for longevity and performance. Our cars are generally tuned by only a handful of high quality tuners with most of them either Lidio or Scott Beer based tunes.

For those of you running a PA on a stock motor please participate in the poll.
If you would like to, please indicate your actual boost and power levels on the stock motor and trouble free S/C miles.
Or if you blew a stocker and want to share the details you can do that also.

If you built a motor, please share your choice of compression level, boost and type of PA.
<!-- / message --><!-- sig -->__________________

[Zack]

I ran 10 on a stock motor once and made 475rwhp.
A few years later I ran 14psi on a stock Ebay motor and made 525 rwhp.

The engines I have built have had 10:1 compression.
The KB makes 17psi with 10:1 and has 16 degrees of timing on 93 octane.

[Rider90]

Stock Trilogy Kit #121 - 9.5 lbs/boost @ 390-400 RWHP. 8,000 trouble free miles so far.

[MarauderTJA]

Jay, I ran 12 Lbs of boost with my stock motor and P1SC with 475 RWHP. With the built motor I have 9.3-1 compression, running 18 lbs boost with the D1SC at 585 RWHP on 93 octane.

[Cobra25]

Jay, I running 11.5 lbs of Boost on a Trilogy S/C, Stock Motor, 467 RWHP & 426 RWTQ on 93 octane Pump gas. I have 12900 miles on the S/C at this time with No Problems.

[juno]

I ran 10 on a stock motor once and made 475rwhp.
A few years later I ran 14psi on a stock Ebay motor and made 525 rwhp.

The engines I have built have had 10:1 compression.
The KB makes 17psi with 10:1 and has 16 degrees of timing on 93 octane.

What cc pistons did you use to get 10:1? Stock head volume?

[DEFYANT]

The boost guage says 13 lbs of boost. The Marauder has been Trilogized since it had only 6000 miles. I am almost at 33K hard and fun miles. It'll run 12.0 - 12.2 all day and dip into 11.9x with some cold air. All done on pump gas - no race tune.

[Zack]

What cc pistons did you use to get 10:1? Stock head volume?

3cc, the stock dish.

[jim geary]

Bought car with 19,600 on it. S/c at 22,500. Getting ready to turn 27,000.
Boost varies between 9.5 and 10. Only drive occasionatly but love ever minute of it.

[MarauderMark]

....

[KillJoy]

Vortech S-Trim.

10PSI

12* of Timing

436HP / 404TQ

Stock Motor and Exhaust

~3k miles

KillJoy

[sailsmen]

10PSI, Vortec, OEM Stock Engine, 44K S/C miles on a 40K mile engine. 447RWHP. Dynoed 20K apart and generated the same Dyno numbers.

Nothing has broke. W/ luck hoping for 100k. When she goes the plan is a OEM used motor.

I have noticed since Katrina 1/2 the time the gas is bad resulting in knocking. I have tired every major gas brand.

I use race gas at the track w/ my street tune. I recc any car w/ a power adder do the same, cheap insurance.

[snowbird]

FIT P1SC # 5 with stock block and tranny.

Running very conservative tune for the only available fuel locally: 91 octane

9.5 pounds give about 415 RWHP and 375 RWTQ

Daily driver even in winter. Never broken or stuck on the road in over 3 years. So far, 12 000 miles N.A. and 22 000 miles on boost and still don't use any oil between oil change (syntetic only).

[Marauderjack]

FIT....P1SC #010

I'm running from 9-10.5 PSI.....Don't know the HP but it is very adequate!!!

I currently have 57K miles on the blower install and have no oil consumption or complaints!!!

Thanks Greg & Dave for a GREAT setup!!!

Marauderjack

[HwyCruiser]

48k miles on stock motor, 13k miles on the s/c (ProCharger P1-SC 380 pulley @ 8 psi), so far no problems knock on wood.