I am having issues getting my Torque Converter seated.
Here is what I need:
A picture of a PI TC FULLY SEATED.
Then, take a steal yardstick across the bellhousing at the center of the TC.
PLEASE HELP ASAP!!!!
KillJoy
I am having issues getting my Torque Converter seated.
Here is what I need:
A picture of a PI TC FULLY SEATED.
Then, take a steal yardstick across the bellhousing at the center of the TC.
PLEASE HELP ASAP!!!!
KillJoy
If it's a PI TC then I hear you really have to hammer them on. Really tight fit.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
yeah steve get a bigger hammer
2010 fusion se
Zack had pictures of mine as well, but I cannot find them.
2017 Niro
Thanks.
Those Pics help less than 3 legged donkey at the Grand Canyon.
KillJoy
2003 MERCURY MARAUDER 300A
Build Date
5/31/02
Sequence#
#363 of 7839 Black Marauders
Dyno tested power
450 RWHP & 405 RWTQ on 93 octane
Best 1/4 mile time to date
12.456@109mph
Visit my Garage
Blackened300a's Garage
Just checked mine Steve. From the face of the bellhousing to the face of the stud pad on my stock converter is exactly one inch. Haven't pulled the TC out yet, just unbolted it and slid it back when I pulled the engine. Hope this helps.
"Bought them to drive on the parkway, not park in the driveway."
Ol' Black I (aka: The Beast)
2003 MM 300A
born 08/07/02, bought on 10/01/02,
expired 4/17/07 (http://www.mercurymarauder.net/forum...ad.php?t=35570) but not retired.
Revived 8/3/08, 660RWHP, 547LBTQ
Ol' Black II (aka: Beauty)
2003 MM 300A
bought on 5/14/2007
Dont make the same mistake I made, If you didn't seat the tc in the trans before installing it, remove it and do it over. The tc has to be seated twice. It has a two step which requires it to be turned once for initail seat and turned and wiggled to get final seat. If not you will play hell and possibly crack the bell housing(which I did).
There are currently 1 users browsing this thread. (0 members and 1 guests)