I'm having an issue with my turbo car, the obd shows the ecm is not getting fuel level data to perform the catalyst drive cycle. I have traced the fuel gauge sender wire to the cluster, where it appears to go to the anti slosh module, I've been looking for a diagram/pin out where it goes from there to get the the ecm.. the dash gauge works fine, just not getting fuel level data to pcm, does anyone by any chance have a diagram?? I'd be forever grateful, I'm Including a picture of the ids screen I took
Thanks seneca
04 twin turbo Marauder custom made by myself 😁
3800stall freddy Brown 4stbe trans 31 spline rear
601rwhp 592rwtq @19psi