I likey.....
I likey.....
WLB
BB#1) 1996 ImpalaSS - 16,500 miles - 100% stock
______________________________ ___________
BB#2) 2003 Marauder (300a) - 34k miles - Daily Driver
#2912 of 7093
Conceived 8/6/2002
Delivered 9/19/2002
Adopted 8/10/2011
Trilogy 242 - Self Installed 9/9/12 (0-60 5.5 sec)
Pioneer 6x8 Front
Legacy 600w 6x9 Rears
JL 6.5 SubWoofer
K&N CAI
Window tint 50% rear/35% front
FBM CHMSL with Strobe mod 7/1/12
DR Deep Aluminum Trans Pan
Sparta FOMOCO Racing 8.8 Girdle
Mo's Dyno Tune
Gorilla Nuts - The System
Ford Racing 4.10s, 31 spline Cobra carrier & axles 7/1/12
Powder Coat Axle Housing 7/1/12
CME HP Rear Control Arms & Watts Link 7/1/12
______________________________ ________________
Rex "SC Cheesehead" Weinbender 11-14-13
Ed "Baaad GN" Linthicum 8-6-2014
Still nothing, Panther is resting while time to heal comes
Enviado desde mi iPhone utilizando Tapatalk
GOLD P74 INTERCEPTOR, A NEW PANTHER IN TOWN.
Oh good grief, where do I start?
Mustang:
Of course, from when I picked up my Mustang at the garage I patronize earlier today. Noticed within the last couple of weeks a noise that sounds like an axle bearing/wheel bearing going bad - can hear it over the radio at 35-40 mph. Tech/Owner drove it home and back overnight and stated that it was just 'tire noise'. I drive my vehicles on a regular basis and know the difference. Checked driver's power seat on a whim and the fuse has apparently blown again - second time this year. Back to the dealer tomorrow for another pink $5 'high current' fuse.
*************************
Marauder:
Removed airbox completely for the first time. Trash and sand in the plastic tray under the air pump. Cleaned (vacuumed) out the trash and sand (as much as possible) and drilled three 7/16" holes using an extended length drill bit. Apparently water and trash were collecting there.
Attempted to install the newly acquired K&N CAI - inadequate fasteners included with the kit. Fasteners included for the air suspension compressor-muffler relocation and the MAF sensor relocation are too short. Had one for the muffler on-hand but not for the MAF sensor - pick'em up tomorrow. Remaining fasteners may be inadequate - too soon to tell.
****************************** **
Not having any luck at the moment finding someone locally who will do the J-mod/tail shaft lube modifications or the rear cylinder head cooling modifications.
Last edited by Invective; 07-19-2018 at 08:46 PM.
Current Garage:
2005 Mustang GT Premium
2019 Ranger Lariat Super Crewcab 4WD
2015 Triumph Trophy SE
“You've gotta dance like there's nobody watching,
Love like you'll never be hurt,
Sing like there's nobody listening,
And live like it's heaven on earth.”
― William W. Purkey
Timing components on a customers car.
Sent from my iPhone using Tapatalk Pro
Well Marauderers. Today I remove the car cover and wash and clean my Panther removing the dust of Sahara which can cause damage to the paint if you leave it long time after cleaned I put the cover again to protect the Panther from elements and sun.
Enviado desde mi iPhone utilizando Tapatalk
GOLD P74 INTERCEPTOR, A NEW PANTHER IN TOWN.
Did a surprise beautiful smokey burnout and left 2 impressive stripes at the local mall at maybe 2/3 throttle with my wife in the car. I must admit scaring her gives me a pleasant jolt....
I was down by the Dupage airport with one of my boys the other day and showed him how there is never cops in that industrial park.
Felt good. Been quite awhile since I’ve done that. Applied about half brake while on the line lock, slowed to probably 20 downing to 1st and let rip at 6 grand for probably 40’ and shifted to 2nd just to see her fall on her face LOL. N/A SUCKS! At least it’s intercooled N/A! LMAO
Sent from my iPhone using Tapatalk
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
Greetings mang !, two problems my Panther was hit in the front driver corner but that not affect engine parts but time later it starts to leak coolant By the intake manifold affecting spark plugs and coils by the driver’s side causing a misfire and to make things more bad battery light start going on the battery and alternator was replaced for newer ones and even that still getting on.
Enviado desde mi iPhone utilizando Tapatalk
GOLD P74 INTERCEPTOR, A NEW PANTHER IN TOWN.
I just finished the installation of the Zack/Jerry big brake kit, and the LED projector fog lamps I bought from Panther Lights. Feelin' pretty good. Need to work on aiming the fogs a bit, though. The new brakes are bit touchy testing them out on wet roads, though. Will have to go for another ride once it all dries up.
"Beast, Jr."
2003 300 A, 4.10:1 gear, JLT CAI, Marty tune, Nitto 420S and 555 tires, NGK TR55 plugs, J-mod, Skull lock knobs, and a new windshield
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
I put the new Mariner radio in! I have a working radio again, ... O and yeah, it has a little black button that allows the internal blue tooth doggle to turn on. Now, I have a stock radio, with blue tooth.
Previous
2003 DPB 232 fo 328.
Gay.
It’s probably been 7 or 8 years since I’ve seen you.
just putting this out there
https://r.tapatalk.com/shareLink?sha...8&share_type=t
Sent from my iPhone using Tapatalk
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
There are currently 4 users browsing this thread. (0 members and 4 guests)