On an eaton swap, when moving the battery to the drivers side, what is the best way to re-attach the power distribution box to the fender? Do you need a bracket or what?
On an eaton swap, when moving the battery to the drivers side, what is the best way to re-attach the power distribution box to the fender? Do you need a bracket or what?
"RescuRauder", Born on 09/02/2003 & rescued on 04/05/2013. #236 of 3214 and #62 of 1237 in Black. CAI, Some kind of tune, Kooks Headers, X-pipe w/Hi-Flow cats, Magnaflow mufflers, Resonators removed, 4.10's, Metco U&L CA and Watts link, Drilled & slotted rotors, now BOOSTED!! Eaton Swapped 12/29/19!!
Sold! 1986 Mustang GT Vert, Black, 5spd, new short block, Powerheads, Crower 15511, gears, exhaust etc.
1968 Ford (Galaxie) XL fastback, 390, factory buckets & auto on floor
2011 Shelby GT500, Kona Blue with SVT Performance Pkg & Navigation, VMP tuned ~550rwhp/550rwtq. Finally Blown!
Make a bracket
We used the brackets that were on it but had the cut off pieces to fit
Last edited by mm svt; 08-20-2018 at 09:34 AM.
thanks!
"RescuRauder", Born on 09/02/2003 & rescued on 04/05/2013. #236 of 3214 and #62 of 1237 in Black. CAI, Some kind of tune, Kooks Headers, X-pipe w/Hi-Flow cats, Magnaflow mufflers, Resonators removed, 4.10's, Metco U&L CA and Watts link, Drilled & slotted rotors, now BOOSTED!! Eaton Swapped 12/29/19!!
Sold! 1986 Mustang GT Vert, Black, 5spd, new short block, Powerheads, Crower 15511, gears, exhaust etc.
1968 Ford (Galaxie) XL fastback, 390, factory buckets & auto on floor
2011 Shelby GT500, Kona Blue with SVT Performance Pkg & Navigation, VMP tuned ~550rwhp/550rwtq. Finally Blown!
There are currently 1 users browsing this thread. (0 members and 1 guests)