Originally Posted by
SC Cheesehead
Why is this even a concern to you, Bradley? I'm very aware that doing an Eaton swap is more difficult than an aftermarket bolt on S/C kit like a Triolgy. Anyone that's attempted an Eaton swap is aware of this, in fact, the challange of overcoming those problems is part of the fun!
What is your point in bringing this up?
It's very obvious that you look down on Eaton swaps, and just as you did over at MCM, it appears that you're trying to create an "Trilogy against Eaton" pissing match. Why?
When you pay too much for something, you pay for dissapointment?
I only posted that because I know Bradley is a stand up guy who can take a poke or two.
Last edited by sailsmen; 08-23-2010 at 07:39 PM.
1/4 Mile Time 11.542 @ 121.19 MPH
195,000 Miles & 275+ Runs Down the 1,320’
541.57 RWHP & 476.64 RWTQ on DynoJet
Tuned by Aric at Injected Engineering
Vortech Super Charger V-2 “T” Trim, 19 PSI
8 Rib Belt, Innovators West 10% Overdrive Dampner
Air to Air Intercooler, Mini-race Bypass
Ford Cobra Remanufactured Long Block
Snow Performance Water-Methanol Injection
Kooks Headers & X Pipe
GT MAF, 60lb injectors, Dash 8, Aero Rails, Twin Ford GT Pumps,
Kinsler Fuel Filter, Kenne Bell Boost-A-Pump
Monroe Sensatrac, Metco Control Arms, Addco Rear Sway Bar
31 Ford Spline Axles & Detroit Truetrac, 4:10 Ford Racing Gears
Dynotech MMC Driveshaft
A-1 Performance Trans, Forced Tailshaft Lube, Carbon Clutches
3,500 RPM Stall Precision Industries Torque Converter
B&M Deep Finned Trans Pan
AeroForce Scan Gauges , Auto Meter Oil, Fuel & Boost Gauges
Kenny Brown Dead Pedal, 35% Tint, Silver Star Head Lights
AutoPage Alarm RS-727LCD, Boston Acoustic NX87