Originally Posted by
RF Overlord
New issue...the wiring diagram shows a 3-wire circuit and the connector to be a round 4-pin, while the connector on the switch is a square 2-pin. Am I looking at the wrong part? It's located in the PS hose just in front of the A/C compressor. Is this not the pressure sensor? The FSM makes no mention of it...
*EDIT* Even weirder: the same sensor on The Blackbird DOES have a round connector...
Can't remember how many wires off hand Bob, but yes that sensor is the pressure sensor. Unplug it and your power steering will come and go as it pleases.
Self proclaimed Builder Of Badassery.
Buy it, Break it, Build it BETTER.
"Since 2004"
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.